Given all the confusion surrounding Seagate's stance on Solid State Disk technology, we decided to sit down with Seagate's representatives with an internal knowledge of the subject in hand. We talked with David Szabados and Rich Vignes on where Seagate is headed with their Solid-State Disk Drive offerings. It was an enlightening discussion and filled in some missing information on why Seagate has been so quiet in the booming market of Solid-State Drives.
I started off by asking the obvious question whether Seagate thought it has missed the boat on the solid-state market. Rich replied by saying that Seagate wanted to avoid a “Me-Too” entry into the SSD playing field. Instead of just shoving another product on the consumer or enterprise segment, Seagate wanted to be different from the other manufacturers releasing SSDs today. As Seagate is aiming at the enterprise they needed to find out exactly what they wanted and to be sure that SSDs would meet the enterprise demands for robustness and performance. Rich assured us that not being first out of the door would not hurt Seagate’s products in the market.
Rich followed up by saying that Seagate wants to focus on the enterprise market for now and give them a product that will fit in with the current levels of performance and endurance expected in that space. Seagate has taken input from consumers to create a product to meet that demand. To start out they are going to begin with SLC-based products [due to customer input] but feel that the SSD must move to MLC [Multi-Level Cell] in order to be a viable volume product. The issue is that in its current form, MLC is not viable as an enterprise standard - only when this format becomes perfected you can expect Seagate to move to MLC.
But the decision to use SLC or MLC is not the only one Seagate is facing, they are also working to determine the appropriate connection to use; SAS or SATA-II. Each one has pros and cons to them. As it stands right now both are limited to a 3Gb/s transfer rate which in many cases can be quickly saturated by an SSDs or array of SSDs. This limitation that they share should be lifted soon as they both move to 6Gb/s in the near future - as you might already know, AMD is going to be the first company with SATA 3.0 interface, coming in the form of SB850 Southbridge chip. SAS [Serial Attached SCSI - Small Computer System Interface] has a couple of major advantages over SATA though. The two biggest are dual port and error correction. SAS has a much deeper level of error correction and can work all the way down to the media and communicate back to the host. SATA has some basic “best-effort” error correction but is not enough for business critical or mission critical applications. In the end I think that SAS will be the ultimate choice for SSDs in the enterprise segment. SAS offers better performance and robustness than what SATA can provide.
The next challenge for Seagate is industry acceptance of capacity; while we see consumer products with capacities as small as 32GB in an enterprise situation this might not be a usable capacity for anything other than a boot drive or for a high-performance swap file. Also, these smaller capacity drives can lose performance as the number of internal parts increase. This puts the 128 and 256GB drives as the main area of interest. Still there is no word on which capacity will eventually be selected. It will come down to a question of capacity Vs performance Vs price. Seagate could put out a 1TB SSD tomorrow but more than likely the cost of this drive would prevent its acceptance. If I were a betting man I would think that 256GB will be the entry point and then a 512GB will pop up within a year of launch.
Continued on the next page...
© 2009 - 2013 Bright Side Of News*, All rights reserved.